Find quick answers to the most common questions about our products, services, and support.

1.Open Hi-RTK software, connect the GPS of V30.
2.After connecting GPS successfully, click Information->iRTK Setting->Set Irtk.
3.Choose the language as you want, then restart the V30, then the voice opened finished.

1.Open the Hi-RTK software.
2.Click”Survey”to go to the interface.
3.Click the “DXF” at the bottom of interface.
4.Then click “Load” to chose dxf or shp file.

Use Hyper Terminal for update firmware.
1.As for total station,go to fileman,then download.
2.Input the pin code 82543,total station will shutdown.
3.Run the Hyper Terminal,connect to total station when prompted.
4.Update firmware by steps.

you must use Hyper Terminal to update firmware.
1.As for total station,go to fileman,then download.
2.Input the pin code 82543,total station will shutdown.
3.Run the Hyper Terminal,connect to total station when prompted.
4.Upgrade firmware by steps.

There are manual about the software to transfer the data.

1.Install driver of data transmission.
2.Transmit data through RS232C communication line.
3.Transmit data through the SD card.
4.Transfer data through USB disk.
5.Transfer data through MiniUSB communication cable.

1.Level total station, put a reflector 30m forward.
2.Switch on the instrument,turn on the laser.
3.Aim at the center of the reflector.
4.Remove the cover in the red frame below.
5.Adjust the triax.
6.Fix the cover back.

Please refer to relevant file below.