Find quick answers to the most common questions about our products, services, and support.

1.Open SuvCE 2.Choose Equip ->Set Rover 3.The manufacture choose: NMEA GPS Receiver , and model choose: Generic As the figure 1 Shows 4.Then click Comms,Type choose Cable, port choose Com3 and Baud choose 19200 as the figure 2 shows. Then click OK 5.Open GPS power control software(a software), and click power on.as figure 3 Shows 6.Then the setup is OK, as figure 4 shows.

Qmini M3 BaudRate Setting Try to set the BaudRate to 19200 with the help of Hi – Q~~Tools~~Com Tool , and please remember that before you send the code, choose a right BaudR ate to show normal data without tick “Hex” , for example Figure 1 is incorrect , and the right one just shown like Figure 2 or Figure 3. And during choosing, we need to connect and close for each trying. After you got normal data please input code: $PSTMSET PAR,1102, 7 ,1 Click send then input $PSTMSAVEPAR. Click send

1.Run Hi-Net Server Software,to Tools Update with post diff result.
2.Mark on use log file, then click on change to enter Post-Processing interface.
3.Import Base raw data and Rover raw data. Input the known point coordinates of Base station.
4.Click onselect, create a file name for the result file, and then click on calculate,wait for finished. The program would process and generate a post-processed file (.log).
5.After processing finished, click on Add .prj to import Hi-Q project;then click on load and update, the processed result would apply to the project.

1.Tool->Data Import.
2.Click Add->change (define the saving path)->Next.
3.Choose coordinate system. Add Predefined means you can use the one that you have defined. Then click OK .
4.Open the xbw file in Hi-Q.Click project(88 project for example)->Open file.
5.Find your .xbw File.
6.Then you finish.

1.Run Hi-Net Server Software, Go to: Tools> Update with post diff result. 2.Mark on “use log file”, then click on “ change” to enter Post-Processing interface. 3.Import Base raw data and Rover raw data. Input the known point coordinates of Base station. 4.Click onselect, create a file name for the result file, and then click on calculate,wait for finished.The program would process and generate a post-processed file (*.log). 5. After processing finished, click on Add *.prj to import Hi-Q project; then click on load and update,the processed result would apply to the project.

1.Open “SSCOM” software,choose right com port and Open port.
2.Choose right parameter,baudrate 19200 etc.
3.Click EXT.
4.Click one by one to send all commands to V30.And then we get IMEI number of V30

1.Prepare a *.txt file that contain the points details in a correct format.
2.Click “Survey”and chose the point library you want.
3.Then click the last second buttons at the bottom of interface.
4.Make sure the points file was copied into your controller,find it out in a location/path.
5.Choose the points file. Click OK.

1.Switch on Receiver, set as UHF mode.
2.Run “GM-xxPx management software” program, choose your COM Port and baud rate “19200” 3.Input the frequence, please click “Apply”.
4.After get all the settings done, please click “Program” ,then wait for program finished.